BackBack
30%

"Coffee is a Hug in a Mug" Signs and Magnets

Write a review

$6.00 $4.20

This file set comes with 3 different coffee cup styles and 2 different sizes -- and you can make them one or 2 layer, whichever you prefer.

The smaller size works great for magnets and the larger are perfect for wall signs. Check Amazon for magnets. There are a ton of great options there.

** Think about your local coffee shops! Put their logo on them and make wall signs or even nametags! **

Learn more under the Project Details tab above. 

* This is a file to cut on your laser. No physical items are included. *

Project Details

NOTES:

  • The designs look great with either one or two layers.
  • You can use whatever material and thickness you prefer. I used 1/8" material.
  • If you're going to make it even larger than the large version I made, it would look great with either 1/8" or 1/4".
  • If you're going to hang it on a wall, I'd either use Command Strips or, if you're using a single layer then you can hang it from any of the existing holes or spaces. If you're using a 2 layer version, then you could add holes to the back layer wherever you like. Just be sure the holes are in a place that's covered by the front layer so they aren't visible.

 

FILE FORMATS:

  • Ai
  • SVG
  • PDF
  • DXF
  • EPS

 

MEASUREMENTS:

* NOTE: You can make them any size you like! See the photos for examples. I made a set that are about 10" tall each. However, I would be careful making them any smaller than the small version I included because the engraving of the small text may be difficult to read if any smaller.

  • Large Version: The 2 cups are ~2.18" x 3.77" and the mug is ~3.6" x 3.5"
  • Small Version: The 2 cups are ~1.37" x 2.36" and the mug is 2.26" x 2.21"

 

AMOUNT OF MATERIAL NEEDED:

  • That depends on how large you want to make them. I made a set that are about 10" tall each and at that size they take about 2/3 - 1 whole sheet of 11" x 19" material. 
  • If you make the larger version I have in the file, you can get at least 15 2 layer cups and twice as many single layer from a single sheet of 11" x 19" material.
  • If you make the smaller version, you can get close to 30 2 layer cups from a single sheet and twice as many single layer.

 

MATERIAL I USED:

  • 1/8" TruFlat Laser Plywood (Oak, Walnut, and Linen)
This section doesn’t currently include any content. Add content to this section using the sidebar.