Phone Chair

This design creates a fun place for your phone to rest while recharging! It's an adirondack-style chair made to hold your phone and it has a hole in the seat to allow your charging cord to run under and out the back so it can be charging while in the chair. It's sized to hold up to the largest phones currently out there (as of October 2019), so it should fit even the widest phone backsides. :)

---

>> Materials I Used:

  • Glowforge Medium Maple and Walnut Plywood
  • Slots are 0.137 in wide
  • ALWAYS measure before cutting. See *IMPORTANT* section

>> Measurements:

  • ~3.35" wide
  • ~6.18" tall
  • ~3.5" deep
  • Seat is 3.8" wide at the back (measure your phone first!)

---

>> IMPORTANT:
ALL MATERIALS VARY IN THICKNESS FROM BATCH TO BATCH, so you will need to measure your materials and adjust the slots if necessary. ALWAYS measure your materials before cutting to be sure the fit will be what you expect.

---

>> PERMISSIONS FOR USE:

Feel free to cut the files for personal use or for reselling the items you make with them.

No attribution required, but thank-yous and shout outs are always appreciated. POSITIVE REVIEWS ARE SUPER HELPFUL!

NEITHER THE FILES NOR THE PICTURES ON THIS POST CAN BE SHARED, RESOLD, OR REDISTRIBUTED IN ANY FORM.

NO RETURNS PERMITTED ON DOWNLOADED ITEMS

No physical items included in this listing.


----

Want to buy your own Glowforge? Use my referral link and save $100-$500!
https://glowforge.us/r/vXGQ2J

You'll get 1 SVG

Buy this
  • $6.00 USD